Requirements for the use of electrostatic spraying equipment

Requirements for the use of electrostatic spraying equipment:

When operating in an electrostatic field environment, do not stand on the plastic board or rubber skin and other insulation boards, so as to avoid the human body in the electrostatic field induction charge, and the potential difference between the ground and the electric shock accident. Since the DC current and voltage used are 100KV, the construction should be carried out strictly in accordance with the operating procedures to avoid accidents.

Check whether the inlet wire of the fuel tank is in firm contact with the ground wire connected to the ammeter, and the inlet wire should be put into the terminal post of the tank; Close the power switch, and the green signal light is on. After the filament is warmed up for 30 minutes, the yellow indicator light is on, the high voltage switch is closed, and the red signal light is on.

Adjust the high voltage reading required by the resistor column, and use the discharge rod to verify that the spray cup has been connected to the discrete pressure before spraying. Press the ammeter button and observe whether its output current is normal. If the output current is abnormal, or there is a discharge sound, the power should be cut off, the use should be stopped, and the circuit should be checked.

The switchboard shell should be grounded when in use; Wipe the lead end of the high-voltage cable clean, plug it in and hold the mother tightly, put the high-voltage cable hanger, and keep a distance of more than 0.5M from other power lines to avoid a breakdown of the high-voltage cable, discharge and accident.

The above introduction is the use requirements of electrostatic spraying equipment, I hope it will be helpful to everyone.